Glassy Logobox

I prepared a background for you to work on to save some time. Go ahead and take it over to your photoshop.

Our first step is to outline our base of the glass box so go ahead and take out your rounded rectangle and set the size to 12. Make sure the background is white.

Drop the opacity of our current outline down to eight percent

Its barely visible now and that's good, don't worry you did nothing wrong. Duplicate the same outline except now clear it of all layer styles and take out your Eraser Tool. Set the tip to approximately the size of 1450 and following the diagram below erase all the white area. Make sure you use the airbrush tip not just the typical brush otherwise you will have a different effect.

So now after airbrushing off the tip, you should have something along the lines of this:

Duplicate the following layer, lets call it the highlight and flip it vertically. Place it to the top of our outline now. So something along the lines of this:

Lets add some lining highlights to our glass box so go back to your original outline and make a copy. Clear it of all the layer styles and using your Eraser Tool with the size tip of 50, follow the diagram below to take of all the unnecessary white.

After that take that layer and flip it vertically and align closer to the bottom. It should look something like this:

Duplicate it once again and just move it to the top.

Add the logo or text you wish to have and get ready for the next step

Duplicate our original outline again and following the Diagram below using your Elliptical Tool cut out a curve.

Lower the opacity to 8% and you are now done.

Below are two examples side by side. A logo/text:

Click to enlarge

Thank you for reading and i hope you enjoyed this tutorial!