Effect "ART Future"

Step 1

We open photoshop and we create the new document 500x500px.

Fill a background black color, name a layer "artground".

Step 2

Choose a layer "artground". Go in menu Filter> Render> Lens Flare.

We choose type of a lens - 105mm Prime, Brightness 110 % and we place a dagger in the center.

Go again in Filter> Render> Lens Flare and choose type of a lens 50-300mm Zoom. Brightness 95 % and we place a dagger in an any corner.

Repeat this step one more or some times.

Step 3

Now go in menu Filter> Distort> Wave

Put adjustments(options) as in figure.

Step 4

Create a new layer, name it(him) "artbosco".

Fill this layer black color.

Go in menu Filter> Render> Lens Flare. Choose there type of a lens 50-300mm Zoom. Brightness make 170 %, and a dagger put at the very bottom in the middle.

Then go in menu Filter> Distort> Pinch. Put factor Amount "-90". Repeat operation once again.

We expose parameter Blending on Hard Light.

Step 5

Create again a new layer with a black background. We name it(him) "artbosco2"

Go in menu Filter> Render> Lens Flare. Choose there type of a lens 50-300mm Zoom. Brightness make 130 %, and a dagger put in the middle.

Now take tool Brush Tool and lead(carry out) two fat features through the center. Color - R- 232 G- 197 B- 200 (#e8c5c8), the size of a brush - 45. Also make once again filter Lens Flare, but it is already strict on the center.

Then go in menu Filter> Brush Strokes> Accented Edges and expose Edge Width: 7, Edge Brightness: 40, Smoothness: 6.

We do(make) degradation with radius 2px (Filter> Blur> Gaussian Blur).

Then go in Filter> Sketch> Chrome

Adjustments(Options):

Detail - 9
Smooth - 0.

Go in Image> Adjustments> Hue/Saturation.

Put parameters:

Hue - 0
Saturation - 70
Lightness -25

We expose Blending on Soft Light.

Step 6

Copy the first layer "artground" and put it(him) to the very top.

We use filter Spherize (Filter> Distort> Spherize) with a parameter-100.

Repeat action two times.

Then go Image> Adjustments> Levels

Put parameters as in figure.

Then go Image> Adjustments> Curves.

Put parameters as in figure.

Further multiply the turned out layer and turn each of new layers on 45-90 degrees (menu Edit> Transform).