Step1: lets start out by creating a new document 300x150 pixels. after the tutorial ends you can make a new document that is much larger than this (perhaps 800x600) and make yourself a nice abstract looking wallpaper! press d to reset colors! After creating you...

Open a new document which is 500x500 px. (the picturs right under, are smaller) Go to: Filter > Texture > Patchwork and use the standart settings Filter > Stylize > Find Edges Filter > Blur > Radial Blur and set it to Zoom and 100 px Image > Adjustments &g...

Create a new document, preferably sizes that have same lengths and width Fill with black Make 2 lens flares, right next to each other, amount 105mm Prime like this: Filter - Artistic - Plastic Wrap: Defaults Filter...

Preparation Things needed- Photoshop Step 1 Open a new document that is 500x500 pixels, RGB, and on a white background. Make sure your foreground color ...

1: This is a very simple tutorial that been banded all over the web since the launch of The Matrix: Reloaded and only uses a few filters. Start off with any size image, but bear in mind that the size of the 'code' will not change, and so it might be w...

1. Start with a New Document Any Size will Work, Then Hit CTRL + D 2. open up a new document in Photoshop And Set your Foreground Color to Black and background Color to White 3. Now Goto Filter > Texture > Grain (Settings Intenset 100% constrast 100% Grain Type:Vertical) 4....

Here we will make the Matrix code. Step-by-step instructions proceed.. 1)Let's open up a new image, 250x250...and let's immediately apply a Grain texture. So, go to Filter>Texture>Grain and apply these settings: 2)Next, we have to go to Filter>Artistic>Neon Glow... ...an...

Here is a nice little tutorial to show you how to electrify your images with lightning in Photoshop. On a new layer, create a black to white gradient, diagonally from the top left, to the bottom right. Fi

Open a new window with: Width:200pixels Height:100pixels Resolution: 72 pixels/inch Mode: RGB color Contents:White Choose Gradient Tool (G) and apply to the image from top to bottom. Make sure your foreground and background colors set to default. Press "D" to set to default. Hold down Shif.....

First of all create a new image and then right away create a new layer. Also set the background color as black, (the image size I used here is 350X500). Now make a selection one pixel wide and make it cover the whole length....