Step 1
We open photoshop and we create the new document 500x500px.
Fill a background black color, name a layer "artground".
Step 2
Choose a layer "artground". Go in menu Filter> Render> Lens Flare.
We choose type of a lens - 105mm Prime, Brightness 110 % and we place a dagger in the center.
Go again in Filter> Render> Lens Flare and choose type of a lens 50-300mm Zoom. Brightness 95 % and we place a dagger in an any corner.
Repeat this step one more or some times.
Step 3
Now go in menu Filter> Distort> Wave
Put adjustments(options) as in figure.
Step 4
Create a new layer, name it(him) "artbosco".
Fill this layer black color.
Go in menu Filter> Render> Lens Flare. Choose there type of a lens 50-300mm Zoom. Brightness make 170 %, and a dagger put at the very bottom in the middle.
Then go in menu Filter> Distort> Pinch. Put factor Amount "-90". Repeat operation once again.
We expose parameter Blending on Hard Light.
Step 5
Create again a new layer with a black background. We name it(him) "artbosco2"
Go in menu Filter> Render> Lens Flare. Choose there type of a lens 50-300mm Zoom. Brightness make 130 %, and a dagger put in the middle.
Now take tool Brush Tool and lead(carry out) two fat features through the center. Color - R- 232 G- 197 B- 200 (#e8c5c8), the size of a brush - 45. Also make once again filter Lens Flare, but it is already strict on the center.
Then go in menu Filter> Brush Strokes> Accented Edges and expose Edge Width: 7, Edge Brightness: 40, Smoothness: 6.
We do(make) degradation with radius 2px (Filter> Blur> Gaussian Blur).
Then go in Filter> Sketch> Chrome
Adjustments(Options):
Detail - 9
Smooth - 0.
Go in Image> Adjustments> Hue/Saturation.
Put parameters:
Hue - 0
Saturation - 70
Lightness -25
We expose Blending on Soft Light.
Step 6
Copy the first layer "artground" and put it(him) to the very top.
We use filter Spherize (Filter> Distort> Spherize) with a parameter-100.
Repeat action two times.
Then go Image> Adjustments> Levels
Put parameters as in figure.
Then go Image> Adjustments> Curves.
Put parameters as in figure.
Further multiply the turned out layer and turn each of new layers on 45-90 degrees (menu Edit> Transform).
